Sheth Group of Industries provides Surface Preparation, Thermal Coatings, Industrial
Coatings and linings, Engineering Services, Consulting Services, Inspection Services and Industrial Cleaning Services. Inspection is very critical factor
in any stage of coating application process. We build Inspection Test Plan
specific to job as per job specification. Quality and life of coating depends
on the application and conditions.
Our Common Inspection Hold Points are:
The number and type of Hold Points will
vary from project to project, however, some hold points are much standard for
most projects. These include:
- Prior to the start of work
- Inspection of steel
- Sharp Edges
- Welds and Weld Splatter
- Taping off Equipment
- Check Abrasives
- Check Air Supply
- After surface Preparation
- Surface Contamination
- Visual Cleanliness
- Immediately prior to application of coatings
- Climatic Conditions
- Materials Inspection
- Observation of mixing coatings
- Following the application of each coat
- Dry Film Thickness
- Holiday Testing
- Recoat Time
- Coating Cure
- Following the cure of the coating
- Final inspection and sign-off
- Dry Film thickness
- Holiday Testing
Additional hold points can be added
based on the requirements of the project.
Inspection plays vital role in coating
projects. Coating failures are not just limited to duration of application but
also after long period of time. Good documented inspection helps to determine
quality of application and inspection carried out at the time of coating.
At Sheth Group of Industries, every job
is followed by our quality control procedures. Our NACE Certified Inspectors
make sure the customer requirements are followed as per specification.
No comments:
Post a Comment